IPSec ikev2

[Sergio_Afonso_C]

Have someone configured a lan2lan tunnel with just ikev2? I have a problem with IDi that presents in the remote peer (it presents private IP) and I do not know if it can be changed / forced to be public IP, without changing the main IP of the cluster. I can nota disable the NAT-T because I have other IPSec tunnels working well with ikev1.

This issue is only with V2.

Thank you!

[Maarten_Sjouw]

the option you are looking for is Link selection, in the cluster object you need to set the outside interface as the primary IP to be used for building VPN's.

[Sergio_Afonso_C]

Hi, this option is only used to set the tunnel. I can stablish the phase1 with the correct IP, but in the phase2 the IDs still the private IP. I have tested all options

Thank you

El 1 dic. 2018 14:59, Maarten Sjouw <[email protected]> escribió:

CheckMates <https://community.checkpoint.com/?et=watches.email.thread>

Re: IPSec ikev2

respuesta de Maarten Sjouw<https://community.checkpoint.com/people/190aef73-58b6-43b8-aee6-8bbb11391e10?et=watches.email.thread> en Installation, Maintenance, and Upgrades - Ver la discusión completa<https://community.checkpoint.com/message/34022-re-ipsec-ikev2?commentID=34022&et=watches.email.thread#comment-34022>

[Steve_Vandegaer]

Did you get this resolved? I have the same issue.

[Sergio_Afonso_C]

NO, I was impossible. Finally I did with ikev1

--

Un saludo

Sergio

De: Steve Vandegaer <[email protected]>

Enviado el: miércoles, 23 de enero de 2019 13:40

Para: Sergio Afonso Coderch <[email protected]>

Asunto: Re: - Re: IPSec ikev2

CheckMates <https://community.checkpoint.com/?et=watches.email.thread>

Re: IPSec ikev2

respuesta de Steve Vandegaer<https://community.checkpoint.com/people/921f9968-89ff-4168-b7c1-b7bc78595431?et=watches.email.thread> en Installation, Maintenance, and Upgrades - Ver la discusión completa<https://community.checkpoint.com/message/38090-re-ipsec-ikev2?commentID=38090&et=watches.email.thread#comment-38090>

[Steve_Vandegaer]

Thanks for the fast response.

[Peter_Baumann]

I think it's better to use IKEv1...

https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solut...

• In some less common conditions, Check Point IKEv2 IPsec VPN up to R80.30 may allow an attacker with knowledge of the internal configuration and setup to successfully connect to a site-to-site VPN server.