Checkpoint VSX with Both L2 (Bridge mode) VS and L3 VS

[JayPatil]

Hello Team,

As part of a new deployment, we would like to create two Virtual Systems (VS) in a VSX chassis:

• One VS in Bridge Mode (Layer 2)
• One VS in Layer 3 mode

We want both VSs to share a common outside interface through a Virtual Switch (VSW).

The Bridge Mode VS will transparently pass VLANs 106, 107, and 109, while the Layer 3 VS will route a separate L3 VLAN.

Please review the attached topology for reference and confirm whether this design is a viable solution. If yes, kindly guide us with the required configuration steps, specifically how to:

• Connect the bridge interfaces of the L2 VS to the Virtual Switch
• Simultaneously connect the Warp interface of the L3 VS to the same Virtual Switch

Your prompt assistance would be greatly appreciated.