CME installation succeeded but no commands available

[greenchair]

Hi,

After a manual install of CME with logs below confirming the installation, there does not seem to be any commands available  ?

I cannot see anything in the documentation about this. Perhaps I have missed something ?

[Expert@hostnameremoved:0]# autoprov_cfg
-bash: autoprov_cfg: command not found
[Expert@hostnameremoved:0]#

thanks in advance. 

[Expert@Ihostnamereloved:0]# tail /opt/AutoUpdater/AutoUpdater.log
*D* %01-24 11:32:44% : MsgListener is waiting for a message
*D* %01-24 11:32:44% : Retrieved message from application message queue: {
"debug_level" : "NORMAL",
"json_req_name" : "change_debug_level",
"res_max_size" : "3072",
"res_queue" : "/fileQv0W1w"
}

*N* %01-24 11:39:16% : Installing component CME version 175, see /opt/CPInstLog/AutoUpdateLogs/CME for more details.
*N* %01-24 11:40:14% : Installation succeeded for component CME
[Expert@Ihostnameremoved:0]#

[Expert@Ihostnameremoved:0]# tail /opt/CPInstLog/AutoUpdateLogs/CME
24/01/2022 11:40:14 All CME services are running properly
24/01/2022 11:40:14 Validation of CME installation succeeded
24/01/2022 11:40:14 ##################### Post-verify actions end here #####################

*N* %01-24 11:40:14% : Installation succeeded for component CME
*N* %01-24 11:40:14% : ----------------------------------------------------------------------

[Dmitry_Gorn]

Hi,

Please try to disconnect and reconnect to SSH and try again. If that helps, I will appreciate your confirmation so we clarify that in the SK.

If the problem still persists, please verify that CME is indeed installed in /opt/CPcme and share the output of cpinfo -y all

Thanks,

Dmitry

[greenchair]

Hi,

Restarting the SSH session did indeed resolve the issue. Updating the SK would be helpful.

thanks