SMB Mobile Application

[Zachi_Schnieder]

Hi All,

By the end of this week, we are planning to start an EA program of our new SMB Mobile Application (WatchTower)

Main features:

• Push notifications for immediate reaction on security and network events
• Easily Manage and switch between multiple security gateways with a single login
• Monitor your network and security status via simplified statistic pages (Traffic, Events, etc.)
• On top of the above, there are many other important features.

 Restrictions:

• Supports only locally managed appliances
• Supported by 700/1400 only
• Supported by R77.20.86 (EA firmware) and Above

If you wish to participate, please send me an Email to [email protected]

Thanks,

Zachi Schnieder

SMB project manager | Check Point SW Technologies

[G_W_Albrecht]

Such small hands 😉

   

 

[Naftali_Oziel]

Noticed build 840 was removed but under download there is build 855. Has anyone tested this?

[HristoGrigorov]

R77.20.86 images were removed for download from all places. And I think I know why 🙂

But there's the note:

Note: The images and package will be available on 31 March 2019 (Sunday). 

[G_W_Albrecht]

855 is still available here: https://supportcenter.checkpoint.com/supportcenter/portal/role/supportcenterUser/page/default.psml/m...

But no GA WatchTower for iOS available yet...

[G_W_Albrecht]

Furthermore, i can see no gain for centrally managed SMBs excepte the resolved issues.

[Naftali_Oziel]

Thanks, concern was I installed build 840 and than seen it taken offline. I will upgrade to 855, not sure if that will change for Sunday release?

[Naftali_Oziel]

Thanks, I seen the note. I just have a concern since I installed build 840 and wondering if it has a major issue and I should revert back? or simply wait and just upgrade to build 855?

[Scott_Chambers]

I had a CP730 that installed for a lab directly with R77.20.86.   After about a week, it completely crashed the threat protection blades and would not save any config changes.

After a case with TAC, they told me that they were getting a bunch of complains for R77.20.86 and requested I roll back to R77.20.85 (which was not possible since I started on R77.20.86 😞 )

No real ETA on the patch (I was told about a month) so I'll be rebuilding this lab on R77.20.85 shortly 😞

[Naftali_Oziel]

Thanks for the note, which build were you on? was it build 855? 

[Scott_Chambers]

Correct on the version (855).

I have it pulled for now and my old PAN-200 running smoothly 🙂

Hoping to rebuild it on R77.20.85 later this week if I get the cycles....

[Naftali_Oziel]

Thanks having TAC look at it and advise r77.20.85 carries it's own challenges too.