CheckPoint 1490 Appliance FTP backup settings

[#1]

Hi. I've searched and tried a lot of posts and guides about the working setting for FTP backup settings for the CheckPoint 1490 Appliance.

I've read I must use and FTP account on port 21 and this is fine but I am not be able at the moment to set the correct path and the correct username. I've used the IP server and the path (without the finale /).

This is my configuration at the moment. Suggestions? Thanks a lot. Best regards to all.

[#2]

Hi. I've searched and tried a lot of posts and guides about the working setting for FTP backup settings for the CheckPoint 1490 Appliance.

I've read I must use and FTP account on port 21 and this is fine but I am not be able at the moment to set the correct path and the correct username. I've used the IP server and the path (without the finale /).

This is my configuration at the moment. Suggestions? Thanks a lot. Best regards to all.

[#3]

Hi. I've searched and tried a lot of posts and guides about the working setting for FTP backup settings for the CheckPoint 1490 Appliance.

I've read I must use and FTP account on port 21 and this is fine but I am not be able at the moment to set the correct path and the correct username. I've used the IP server and the path (without the finale /).

This is my configuration at the moment. Suggestions? Thanks a lot. Best regards to all.

[gtatarella]

Hi. The The firmware version is R77.20.80 (990172392). I'm using a simple fileserver on which is configured a local user with FTP rights on IIS. I already use this method to backup other devices.

[gtatarella]

Hi. The The firmware version is R77.20.80 (990172392). I'm using a simple fileserver on which is configured a local user with FTP rights on IIS. I already use this method to backup other devices.

[Chris_Atkinson]

R77.20.80 is out of support and you should consider upgrading to R77.20.87 taking into consideration that interim steps may be required.

Refer also: https://www.checkpoint.com/support-services/support-life-cycle-policy/ 

[Chris_Atkinson]

R77.20.80 is out of support and you should consider upgrading to R77.20.87 taking into consideration that interim steps may be required.

Refer also: https://www.checkpoint.com/support-services/support-life-cycle-policy/ 

[G_W_Albrecht]

Remove the ftp:// from path and it should work !

[G_W_Albrecht]

Remove the ftp:// from path and it should work !