Export configuration SG82-Appliance

[Martin_Peinsipp]

Hello!

I have to replace about 30 SG80-Appliances (new appliances are 1450 appliances). Is there a way how I can transfer the configuration between a SG80 and a 1450 appliance. In the Clish "show config" is not available.

Best regards

Martin

[PhoneBoy]

What version of code are you running on the SG80s?

I believe you should be able to do a show configuration if you're running an R75.20-based version.

[G_W_Albrecht]

This looks like your firmware is about R71.45 - there is no show config in that version, so you have to install a R75.20.x firmware for export! See also my CheckMates document Configuration transfer between different SMB models.

[Martin_Peinsipp · Accepted solution]

Hi!

I have installed R75.20.69 (Bulid 983004056) and there is no "show configuration" in the clish available. The Check Point-Support told me, that there is now official way how I can transfer the configuration. I have to migrate the configuration manually.

Best regards

Martin

[G_W_Albrecht]

I have to confirm that - i just had a look at my R75.20.69 SG80, and the command is missing there 😞