Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Iron

DHCP Relay - i don't think i'm doing this right

Jump to solution

Hi Everyone,

I'm trying to configure my Checkpoint R80.30 ClusterXL to act as a DHCP relay for clients on a VLAN interface.

I don't think i'm doing it right because it's not working.

I have configured a DHCP relay in each FW using GAIA with the FW interface as the Primary address and the "Relay to Server" using the IP of the DHCP server. - Should i be using the Cluster VIP, or does this not matter?

 

I have configured a rule for any source to 255.255.255.255  DHCP-request

and

a rule for the client subnet to the dhcp servers using DHCP-request

 

I have also configured a rule for the FW interface(s) + VIP to 255.255.255.255  and to the client subnet using DHCP -reply

and another rule for the DHCP server IP to 255.255.255.255  and to the client subnet using DHCP -reply

I'm not seeing any hits on these rules and the client is not getting a DHCP IP.

 

What am i doing wrong, or not doing?

1 Solution

Accepted Solutions
Highlighted
Iron

Hello. Follow sk104114.

In addition to other checks you need to configure 4 firewall rules using the image below as an example.

https://supportcenter.checkpoint.com/supportcenter/portal?evRelay.jpgentSubmit_doGoviewsolutiondetails=&solut...

View solution in original post

2 Replies
Highlighted

Did you check the SK for DHCP using the new services?

Regards, Maarten
0 Kudos
Highlighted
Iron

Hello. Follow sk104114.

In addition to other checks you need to configure 4 firewall rules using the image below as an example.

https://supportcenter.checkpoint.com/supportcenter/portal?evRelay.jpgentSubmit_doGoviewsolutiondetails=&solut...

View solution in original post