Cluster R80.10

[Adem_Tipura]

Hi, I've created/tried to create a cluster using two r80.10 FWs installed on vmware. I have succsesfully finished wizard for creating cluster and its state is UP, but when I issue cphaprob state command on each member it only shows local member and it's marked as active. All interfaces are UP. Any help with this issue, am I missing something because it's my first time setting a CP cluster? 

[Gomboragchaa]

Output of 'cphaprob stat' on cluster members shows only current member in Active state .

I hope this could helps you.

[Vladimir]

If you are trying to set it up in ESXi environment, please make sure that the networking is configured according to How to configure Virtual Switch (vSwitch) for cluster of Security Gateways Virtual Edition in Networ... 

[Adem_Tipura]

Thanks Vladmir, after changing settings on ESX host everything looks great.

[Danny]

Cluster members in VMware? Is this a VE (Virtual Edition) or just a test setup? I recommend checking your VM network settings first.

[ravinder_gulia]

Please check, both are in sync or not?