CLINFR0329

[C_M]

While trying to change passwords in clish I get the following errors:

CLINFR0329 Invalid command:'set user admin password

CLINFR0329 Invalid command: 'set expert-password

Please advise.

[Danny]

You either don‘t have the required permission to run these commands or you are not in Clish mode. Post a screenshot.

[C_M]

See attached screenshot.

[PhoneBoy]

Leave off CheckPoint from both commands.
You will be prompted for the password you wish to use.

[PhoneBoy]

If set expert-password doesn't work, you must be in an early version of Gaia.
The command should be set expert-password plain in that case.
set user admin password should work even in R75.40, though.
That said, you can also try set selfpasswd to change your password, assuming you are logging in as the admin user.

[C_M]

R80.10

[Maarten_Sjouw]

try to use the Tab key while typing: set user admin pass<Tab> and see if it fills it to password and then hit enter to enter your new password.

[omar_1212]

Hey, 

I am new to checkpoint here. Did you ever find what was the issue for this  as I am stuck on this at the moment while trying to configure an out of the box checkpoint.

Thanks

[PhoneBoy]

"Out of the box" please elaborate.
What hardware (if VM or Open Server, please specify the RAM/CPU/Disk allocated) and what version/JHF?