cancel
Showing results for 
Search instead for 
Did you mean: 
Post a Question
Highlighted

R80.20 Management and vpn domain Edge N

Jump to solution

Hello,

We plan to update MGMT (MDS) R77.30 to R80.20. This MGMT manages geteways including Edge N/X. Edge N is referred to as supported by R80.20. But when testing we found out that to Edge N not transmitted vpn domain behind central cluster and traffic inside tunnel does not work. Has anyone faced this issue? While there is a temporary solution to transfer these devices to local management or to the dedicated MGMT R77.30.

Andrey

0 Kudos
1 Solution

Accepted Solutions
Wolfgang
Silver

Re: R80.20 Management and vpn domain Edge N

Jump to solution

Andrey,

we observed the same.

If you don‘t use VPN with the edges everything will be fine. The tunnel is established but no traffic is going this way.

A workaround is, to not install R80.20 policy to the edge device or the LSM-profile if used. But with this workaround you can‘t change anything at the policy for the edges.

We used these, because we were on the way of replacement of the edges with 14xx appliances. This worked for us for an half year, now we replaced all edges and we can change the policy for the new 14xx.

We never opened a case for this.

Wolfgang

0 Kudos
5 Replies
Admin
Admin

Re: R80.20 Management and vpn domain Edge N

Jump to solution
Recommend a TAC case so we can investigate.
0 Kudos

Re: R80.20 Management and vpn domain Edge N

Jump to solution

TAC with RnD are investigating this issue. We are waiting the result.

 

Andrey

0 Kudos
Wolfgang
Silver

Re: R80.20 Management and vpn domain Edge N

Jump to solution

Andrey,

we observed the same.

If you don‘t use VPN with the edges everything will be fine. The tunnel is established but no traffic is going this way.

A workaround is, to not install R80.20 policy to the edge device or the LSM-profile if used. But with this workaround you can‘t change anything at the policy for the edges.

We used these, because we were on the way of replacement of the edges with 14xx appliances. This worked for us for an half year, now we replaced all edges and we can change the policy for the new 14xx.

We never opened a case for this.

Wolfgang

0 Kudos

Re: R80.20 Management and vpn domain Edge N

Jump to solution

Wokfgang,

Thanks. I'll keep that in mind. We can't replace all Edge N/X to 14xx quickly too.

Andrey

0 Kudos

Re: R80.20 Management and vpn domain Edge N

Jump to solution

VPN-1/UTM-1 Edge X is out of support since 31-May-2015, UTM-1 Edge N since May-2018 - but as the R80.20 Release Notes state that it can manage UTM-1 Edge N 8.1 and higher, something is missing here... Only UTM-1 Edge Industrial has support until 26-May-2020.

0 Kudos