JHFA version in smartconsole

[Adam276]

One thing I have been wanting is to see the JHFA version in smartconsole.  I found an article today that mentions that starting with R81.20 JHFA 38,  It is viewable in the Gateways & Servers area.  I was unable to find it.  Is it buried somewhere or is the article incorrect?  The management and gateways have newer JHFAs installed than 38 on R81.20.

See option 3 below...

https://support.checkpoint.com/results/sk/sk98028

• How to check the Take number of the currently installed Jumbo Hotfix Accumulator (if it is installed...
  

  1. On R81.x and higher with Jumbo Hotfix Accumulator, run this command in the Expert mode:

     cpinfo -y all

  2. In Gaia Portal (CPUSE) > Upgrades (CPUSE) > Status and Actions.
     Use the filter near the help icon and select "Installed" packages.
     The installed Jumbo Hotfix Accumulator will appear in the list.
  3. Starting R81.20 Jumbo Hotfix Accumulator Take 38, you can view the installed Jumbo Hotfix Accumulator Takes in SmartConsole > Gateways and Servers.

[Lesley · Accepted solution]

Should show here, can you share screenshot? 

If it shows N/A check sk: https://support.checkpoint.com/results/sk/sk168572

[Adam276]

Interesting.  The 2 clusters and management are all R81.20 JHFA 105 and above.  Strange that it doesn't show it on the gateways on Smartdashboard for these systems then.

[Adam276]

I forgot to include it but they all show the recommended JHFA... it is just the current JHFA that it doesn't show.

[Adam276]

I found this article which seems relevant.  The solution seems a little different than the article you pointed to.  Thanks for pointing me in the right direction.  I will give it a try on the next maintenance.

SmartConsole does not display the installed Jumbo Hotfix Accumulator for Security Gateways
https://support.checkpoint.com/results/sk/sk184851