Remote Endpoint Security VPN takes 1.5 minutes after connection to pass traffic after SCV enabled

[dmurray_HTE]

After configuring Device Check of Reg key using $FWDIR\conf\local.scv,

When I connect, after being authenticated, on the client I can see it is compliant, and the connection is successful.

On the client if I ping to a resource behind the firewall, it takes approx 1.5 minutes before ping responses are received.

When I look at the logs, only after FW1_scv_keep_alive is logged does the client start encrypting traffic from/to the remote client. (See image below)

Any thoughts to how this time can be reduced/eliminated would be greatly appreciated.

Client is EndPoint Security E81.10 Build 986100611

FW Gateway is type 2200 Appliance running R80.20

Cheers

[dmitry_shesterk]

Hello, I have a similar problem, how did you solve it?

[dmitry_shesterk]

Hello, I have a similar problem, how did you solve it?