- CheckMates
- :
- Products
- :
- Quantum
- :
- Remote Access VPN
- :
- Changing the Standalone Remote Access Client flavo...
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
Are you a member of CheckMates?
×- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Changing the Standalone Remote Access Client flavor
I have mentioned this in an answer here, so i publish the little ditty also by itself. When installing the E80.80 Standalone Windows VPN client from sk122513, you can select one of three different flavors before installation starts: default Endpoint Security VPN, Check Point Mobile or SecuRemote (client sans OfficeMode).
But if you did already install one of these flavors of the RA VPN client, you don't need to uninstall and reinstall if you want to change the client type 😁 ! You can just update the Windows registry with the values: "EndpointSecurity", "Mobile" and "SecuRemote" to change the users client type in the key: HKEY_LOCAL_MACHINE\SOFTWARE\Wow6432Node\CheckPoint\TRAC client_sub_type=SecuRemote
This of course is not suggested by CP, not supported at all and based on the use of dreaded tool RegEdit 😎 .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
good to know. Thanks for sharing!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you so much for posting this information!!! I was going crazy trying to get SecuRemote to install on a machine that had EndpointSecurity previously installed (removing app, registry entries, etc and it still seemed to remember the prior install).