- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
LOM stop accessing Resolved, TIP
If the LOM loses its configuration in the first wizard, and stops accessing.
Access via Gaia expert and reconfigure with the following commands::
ipmitool lan print 8
To see the current LOM configuration
In the case above, the Source IP address was with DHCP Address, and without IP
So with
ipmitool lan set 8 <press enter>
I looked at the parameters, changed IP address Source to static
So I configured the LOM's default IP again to have access to it again.
Other good commands
service ipmi start
ipmitool bmc reset cold
service ipmi stop
Clish Commands LOM
Bellow a good sk
How to check the current LOM firmware version on Check Point appliances
https://support.checkpoint.com/results/sk/sk101250