- CheckMates
- :
- Products
- :
- Quantum
- :
- SmartMove
- :
- Re: Issue with SmartMove conversion tool
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
Are you a member of CheckMates?
×- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Issue with SmartMove conversion tool
Hello everyone,
Im not sure if this is the right board to post this or if anyone can help, but figured would try. I used smartmove before and worked well, but have an issue where a new customer gave me the cisco asa config and for some reason, converts all the objects fine, BUT when it comes to rules, though there are around 300, it only shows 4, which makes no sense.
I compared the runn config file with another customer's file that worked and I cant see any major differences, except new config is much larger, but that should not really matter.
If anyone has any ideas, please message me offline, as I cant sadly provide the config file here, due to security reasons.
tx a lot
Andy
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks as always Dameon, appreciated the fast response. I will keep checking, but its just odd that its not working...
Andy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
issue fixed...in case this helps anyone, here is what I asked customer to do:
From cisco enable mode, run conf t and then this:
pager 0
wr mem
What this does is actually enforces any commands to run continuously without having to press space bar. Once client did this and generated show runn, they sent the file and I was able to import everything into smartmove.
Thanks guys and be safe!
Andy