- CheckMates
- :
- Products
- :
- Quantum
- :
- Security Gateways
- :
- R81.10 after upgrade cluster not able to sync
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
Are you a member of CheckMates?
×- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
R81.10 after upgrade cluster not able to sync
HI All,
I have made a setup for a cluster of 5600 series devices with Gateway and management. have some policies installed. While doing the clean image installation and hotflix, I am not able to peer or sync my FW01 to FW02.
1) I have made my FW01 as active before doing the clean image on FW02.
2) Install the R81.10_T335 and Check_Point_R81_10_JUMBO_HF_MAIN_Bundle_T150_FULL.
3) Make my FW02 a secondary while running the wizard. also given IP the same as given before.
4) After clean image installation is complete, I am able to sync with my FW01, but after clean image installation of my FW01, I am not able to sync with my FW02. Also, it is asking to run the new cluster wizard.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is the SMB corner - can @_Val_ put your post into SMB ? Or please copy the text, delete the post and create a new one in Security Gateways!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
done
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What can't you sync? The cluster? The Management Database?