- Products
- Learn
- Local User Groups
- Partners
- More
Check Point Jump-Start Online Training
Now Available on CheckMates for Beginners!
Welcome to Maestro Masters!
Talk to Masters, Engage with Masters, Be a Maestro Master!
ZTNA Buyer’s Guide
Zero Trust essentials for your most valuable assets
The SMB Cyber Master
Boost your knowledge on Quantum Spark SMB gateways!
Check Point's Cyber Park is Now Open
Let the Games Begin!
As YOU DESERVE THE BEST SECURITY
Upgrade to our latest GA Jumbo
CheckFlix!
All Videos In One Space
I have configured bond on two interfaces eth1 and eth2. Both of the interfaces are external facing and connect to our ISP with same address range at different locations. I have configured them on active/standby mode.
I want to know if I can set monitoring on the interface such like a ping fails to 8.8.8.8 for 10 times failover to another interface in the bond?
for example from eth1 if ping fails to 8.8.8.8 then failover to eth2 and make eth 2 primary until eth1 comes back up and vice versa
please help me out with this
You can change routes or cluster member status based on pings.
Changing interface status of a bond member is likely possible using scripting but isn't a natively supported approach that I'm aware of so would require an RFE.
Again, this is not a common use case for a bond that we see in the field.
About CheckMates
Learn Check Point
Advanced Learning
YOU DESERVE THE BEST SECURITY