- Products
- Learn
- Local User Groups
- Partners
- More
Check Point Jump-Start Online Training
Now Available on CheckMates for Beginners!
Why do Hackers Love IoT Devices so Much?
Join our TechTalk on Aug 17, at 5PM CET | 11AM EST
Welcome to Maestro Masters!
Talk to Masters, Engage with Masters, Be a Maestro Master!
ZTNA Buyer’s Guide
Zero Trust essentials for your most valuable assets
The SMB Cyber Master
Boost your knowledge on Quantum Spark SMB gateways!
As YOU DESERVE THE BEST SECURITY
Upgrade to our latest GA Jumbo
CheckFlix!
All Videos In One Space
Hi All,
i have concern to implementation LACP on Security Gateway.
the concern is should i must set target of bonding interface security gateway has applied LACP or no?
example:
there is one cluster with 2 member:
let's say FW1 and FW2, under this cluster there is an IPS dedicated with HA.
If FW1 has bonding eth3 - eth4 and another side FW2 has bonding same interface like FW1.
The question is, should i must set LACP on Mcafee or if Mcafee don't support LACP, can i use switch to receive interface LACP from cluster checkpoint and then from switch go to Mcafee1 and 2.
Hopefully my explanation is clear, if not i will send that topology.
Note: i have tried this mode between 6800 appliance series with standalone configuration and connected to 1800 appliance quantum spark, two this appliance has applied LACP configuration.
Thanks Regards
Dio Aditya Pradana
LACP is common for load-sharing type Bonds (amongst other available modes) but you should align the configuration with what the adjacent device supports/expects
Refer:
About CheckMates
Learn Check Point
Advanced Learning
YOU DESERVE THE BEST SECURITY