Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Maarten_Sjouw
Champion
Champion

Serial port remote access 1500

I was trying to setup my 1590 with R82.20.10 to use reverse telnet to connect to a console of a connected switch, only to find that in the Web-UI the option is no longer there (it was in 1450 with R77.20) and on the command line when you try to use the command for it, this error shows:

set serial-port mode console passive-mode
Could not set serial-port mode: Value is not valid

passive-mode - Allow connection from a remote telnet server to a device connected to the serial port

Will this functionality come back or not?

Regards, Maarten
0 Kudos
5 Replies
PhoneBoy
Admin
Admin

It looks like the syntax is different in the R80.x code, but believe it's still there: https://sc1.checkpoint.com/documents/SMB_R80.20.02/CLI/Content/Topics/170636.htm?Highlight=passive-m... 

0 Kudos
Maarten_Sjouw
Champion
Champion

Irrelevant which additional options you add, the error remains the same. The option for Passive mode is gone completely from the WebUI, where it was before in the advanced settings.

Regards, Maarten
0 Kudos
Chris_Atkinson
Employee Employee
Employee

It may only be relevant to the 1570R with the physical DB9/RS232 connector but will confirm.

CCSM R77/R80/ELITE
0 Kudos
Maarten_Sjouw
Champion
Champion

It was enabled on all 1400 models and as Gunther says below it was also available in the previous R80.20 versions...

Using a Roll-Over cable to the switch will allow access to the console when all networking has failed, or the switch has failed...

That is not only relevant when using the 1570R version.

Regards, Maarten
0 Kudos
G_W_Albrecht
Legend
Legend

Looks it was present in R80.20.0x still - missing since (at least) R80.20.10 are the Advanced Settings:

Serial port - Flow control
Serial port - Mode
CCSE CCTE CCSM SMB Specialist
0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events