Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Wei_Soon_Heng
Contributor
Contributor

Quantum Spark cluster locally managed is stuck at "step 3" of primary member

Hi All,

Did anyone experiences the issue stuck at step 3 "Applying settings(This may take a few minutes)" at primary member when configuring cluster(locally-managed)?

Please refer to screenshot below:

0 Kudos
4 Replies
Chris_Atkinson
Employee Employee
Employee

Please confirm the version used and attach the screenshot?

CCSM R77/R80/ELITE
0 Kudos
Wei_Soon_Heng
Contributor
Contributor

The firmware version is R81_10_08 with build number 996001608. I tried to upgrade to latest build number  996001683 but issue still persists. I tried refresh browser after waiting for one hour, and it shows "loading data" in page of High Availability. The output of command "configload_status" showing cluster service "Queued to Run" which cause the secondary member having error establishing trust when joining HA to primary member.

0 Kudos
G_W_Albrecht
Legend Legend
Legend

I would suggest to try a firmware install from CLI:

- Perform the following Expert Mode command in order to allow SCP protocol connection:

bashUser on

- Please download the latest GA version offirmware for your appliance
- Enter the appliance via WinSCP connection of SCP protocol and upload to the /storage directory the latest GA version image.
- Before uploading image to /storage directory, all the files in this directory have to be deleted.
- Perform the following Expert Mode command for a manual upgrade via CLI:

upgrade_revert_image.sh /storage/%FILENAME% upgrade safe

 

CCSE / CCTE / CTPS / CCME / CCSM Elite / SMB Specialist
0 Kudos
Pedro_Espindola
Advisor

Try disabling out of state protections in advanced settings of both members, create the cluster and when everything is fine, then enable it again.

Also, I don't know if this is your case, but I had this kind of issue when creating a cluster connected to Spark Management in Infinity Portal, which has lots of limitations. There will be no connection sync and the standby member will not be able to complete TCP connections or ping, unless you use the cluster fold option, which forces routing of outbound connections through the active member using VIP address.

0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events