Quantum Spark Redundant IPsec tunnels Using Dual ISPs ISSUE

[#1]

I am facing an issue with redundant IPsec tunnels using dual ISPs.

WAN link failover is working correctly, and the tunnel shifts to the other ISP as expected. However, the session still retains with the existing Tunnel Creation Time although WAN IP is changed.

The tunnel should automatically reset when switching to a different ISP, but it doesn't do so on its own.

The tunnel works again after manually resetting it by clicking Delete All SAs for the Selected Peer.

I hope you understand my query. Please provide any suggestions on how to reset the tunnel automatically or if there are any special configurations required.

I have also attached the error screenshots.

[#2]

I am facing an issue with redundant IPsec tunnels using dual ISPs.

WAN link failover is working correctly, and the tunnel shifts to the other ISP as expected. However, the session still retains with the existing Tunnel Creation Time although WAN IP is changed.

The tunnel should automatically reset when switching to a different ISP, but it doesn't do so on its own.

The tunnel works again after manually resetting it by clicking Delete All SAs for the Selected Peer.

I hope you understand my query. Please provide any suggestions on how to reset the tunnel automatically or if there are any special configurations required.

I have also attached the error screenshots.

[#3]

I am facing an issue with redundant IPsec tunnels using dual ISPs.

WAN link failover is working correctly, and the tunnel shifts to the other ISP as expected. However, the session still retains with the existing Tunnel Creation Time although WAN IP is changed.

The tunnel should automatically reset when switching to a different ISP, but it doesn't do so on its own.

The tunnel works again after manually resetting it by clicking Delete All SAs for the Selected Peer.

I hope you understand my query. Please provide any suggestions on how to reset the tunnel automatically or if there are any special configurations required.

I have also attached the error screenshots.

[#4]

I am facing an issue with redundant IPsec tunnels using dual ISPs.

WAN link failover is working correctly, and the tunnel shifts to the other ISP as expected. However, the session still retains with the existing Tunnel Creation Time although WAN IP is changed.

The tunnel should automatically reset when switching to a different ISP, but it doesn't do so on its own.

The tunnel works again after manually resetting it by clicking Delete All SAs for the Selected Peer.

I hope you understand my query. Please provide any suggestions on how to reset the tunnel automatically or if there are any special configurations required.

I have also attached the error screenshots.

[khineminn · Accepted solution]

Quantum SPARK 1800

R81.10.10 (996002945)

After changing to DPD from CP Proprietary in Advanced, this issue has been resolved and dual IPsec tunnels work fine.

@PhoneBoy  Thank you very much.

[khineminn · Accepted solution]

Quantum SPARK 1800

R81.10.10 (996002945)

After changing to DPD from CP Proprietary in Advanced, this issue has been resolved and dual IPsec tunnels work fine.

@PhoneBoy  Thank you very much.

[khineminn · Accepted solution]

Quantum SPARK 1800

R81.10.10 (996002945)

After changing to DPD from CP Proprietary in Advanced, this issue has been resolved and dual IPsec tunnels work fine.

@PhoneBoy  Thank you very much.

[skandshus]

Are you able to elaborate what you did because i have the same issue 🙂

[skandshus]

Are you able to elaborate what you did because i have the same issue 🙂

[skandshus]

Are you able to elaborate what you did because i have the same issue 🙂

[PhoneBoy]

This screenshot should help.

[PhoneBoy]

This screenshot should help.

[PhoneBoy]

This screenshot should help.