Lan1 and lan2 are bridge mode. IPS doesn't work

[Lei_Liu]

[15:09] Lei Liu

Hi expert, our SE has a POC on 1600 SMB apliance, he enabled FW, IPS, AV/AB software blades on  the  1600 apliance of central managemnt. 1.wan and Lan2 are route mode. IPS works well. it's ok. 2.Lan1 and lan2 are  bridge mode. IPS doesn't work Question: we want to konow that "Lan1 and lan2 are  bridge mode. IPS doesn't work " this is a limition?

[G_W_Albrecht]

Bridge mode is not the cause - WAN to LAN traffic is inspected as set in IPS Protection Engine Settings. But not LAN to LAN: In Default mode, LAN to LAN Deep Packet Inspection is off - you can enable it in Advanced Settings > Statefull Inspection.

[Lei_Liu]

Dear sir,

Thank you.  the SMB appliance is a central  management , i can't find "Advanced Settings > Statefull Inspection." on smartconsole.

Could you help me point our where it are?

Thank you very much.

BRs,

Lei

[G_W_Albrecht]

No, i would suggest that you ask TAC for a solution !

[Lei_Liu · Accepted solution]

Dear sir,

I found It should be solved via sk102296.

Thank you for your help!

You are very nice.

BRs,

[G_W_Albrecht]

I would have been reluctant to suggest GUIdbedit procedures 😎.