How to see neighbors of a physical port?

[bezeq_int]

Hello,

We're using checkpoint quantum spark 1590 appliance, version R81.10.08,

Wanted to know how to learn the neighboring addresses of a physical port, in juniper for example it's " show lldp neighbors",

Tried using the commands "lldpneighbor" or "show lldp neighbor-info" on normal& expert mode, didn't recognize the command 

[PhoneBoy]

LLDP is not supported on Quantum Spark appliances.

[bezeq_int]

thanks for the answer,

Is there any other way to find through the port what mac addresses are connected, a command to see what mac the port learns other than "lldp neighbor"?

[PhoneBoy · Accepted solution]

In Logs and Monitoring > Status > Assets, there should be a list of devices and the interface they are connected to.
Not sure if there’s a CLI command that shows this. 

[bezeq_int]

Ok thx a lot for the reply anyway

[Chris_Atkinson]

commands like "arp -a" ?

[bezeq_int]

not exactly, arp shows everything that is connected to the device/interface, not the peer itself

[Chris_Atkinson]

Unfortunately we don't have lldp/cdp like command on Spark as others have stated.

[MikeB]

Are there any plans to support LLDP/CDP protocols in Quantum Spark at some point??

[PhoneBoy]

Not familiar with specific plans for this, but it could come as a result of future releases as we synchronize Gaia and Embedded Gaia a bit more.

[Chris_Atkinson]

I'll see what's planned for R81.10.17 and revert.

[Dafna · Accepted solution]

Hi,

Please try to use:

sw info hosts
to see all the macs for the vids.

sw info hosts vid X
with X being the vid number to check for specific vid

If this meets your requirements, we can consider adding a clish command for this functionality.

[PhoneBoy]

It should be noted @bezeq_int these are expert level commands.
However, it appears that sw info hosts will show information similar to what I see when I go to Logs and Monitoring > Status > Assets in the WebUI.