Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
peter_schumache
Collaborator
Jump to solution

Need to change bootp config to dhcp_request when upgradig SmartCenter to R80.x

The pre_upgrade_verifier of R80.x gives a warning, that we use the service "bootp" in our existing R77.30 policies, and that we should replace it with the new dhcp_xxx services.

Our gateways DO NOT ACT as DHCP Relays, they just forward unicast bootp requests, which were relayed on routers behind the firewall.

Is it therefore correct that we can just replace all instances of the "bootp" service with "dhcp_request"

0 Kudos
1 Solution

Accepted Solutions
Wolfgang
Authority
Authority

Peter,

using the new DHCP services is not mandatory.

Using the bootp like you does, there is  no need to change to the new dhcp services.

Configuration of IPv4 BOOTP/DHCP Relay using new services describes really good the new DHCp services and there need or not.

For youre use case, snip from the document:

"For backwards compatibility, the legacy DHCP (BOOTP/DHCP) services can still be used with newer Security Gateways and Security Management Servers."

The new DHCP services allows an improved configuration of the rules for DHCP relay.

Wolfgang

 

View solution in original post

1 Reply
Wolfgang
Authority
Authority

Peter,

using the new DHCP services is not mandatory.

Using the bootp like you does, there is  no need to change to the new dhcp services.

Configuration of IPv4 BOOTP/DHCP Relay using new services describes really good the new DHCp services and there need or not.

For youre use case, snip from the document:

"For backwards compatibility, the legacy DHCP (BOOTP/DHCP) services can still be used with newer Security Gateways and Security Management Servers."

The new DHCP services allows an improved configuration of the rules for DHCP relay.

Wolfgang

 

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events