Default route on Standby Member not showing once i checked configuration default route command is configured and trying to ping 188.8.131.52 error is Network is unreachable meanwhile active member working fine.
It is perhaps the same issue as described here, I suspect and should be resolved using same methods:
Problem accessing standby cluster member from non-local network
Most likely connectivity to the next hop is lost. Check your next hop that's defined on default route.
Hi Kaspars, Next hop is same as active member
In active member default route is showing but not showing on standby member
Hi! I had the same issue a few weeks ago, do you have the ping option enablen in the static route? are you using more than one default route?
Hi Vanesa, yeah i enabled ping on static route and i'm using single default route
If you had the same issue that mine, the default route in the standby member appeared when you disable the ping option.
I have two default route so... this option was necesary for me... (I had to install the hotfix 142 but it isnt in GA yet)
Many many thanks to you , As of now issue resolved. i disabled ping on default route both firewall have default route.
Thanks again for your support !
Looks like this issue is addressed in the Jumbo Hotfix Take 154 released just now:
Thanks Vladimir, Update showing in CPUSE, Will install As soon as possible.
Retrieving data ...