Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Huseyin_Rencber
Collaborator

cpview command on scalable platforms

After R76SP.50 version cpview tool is became available. But something strange on this tool, system uptime :4908 days ??

NTP configured, output of "show uptime" is true on all sgms.

4 Replies
Kaspars_Zibarts
Employee Employee
Employee

Ours on Take 62 look correct

0 Kudos
Huseyin_Rencber
Collaborator

I couldn't find any info about cpview in list of resolved issues, anyway it seems solved. I will check this out after install the fix. Thanks

0 Kudos
Gus_Schuerger
Employee Alumnus
Employee Alumnus

There is a file, $FWDIR/conf/fwha_ch_uptime, which stores the uptime when the first SGM in the chassis booted.

This file is cleared upon boot and then pulled during normal configuration cloning.

So if it somehow becomes wrong, it will remain wrong until one of two things happens:

1. All SGMs are rebooted simultaneously

2. Manually reset it

Try running this command from expert mode to manually reset the chassis uptime:

cpha_blade_config reset_uptime_internal

Huseyin_Rencber
Collaborator

Thanks Gus, I've reset the uptime.