AnsweredAssumed Answered

Add Interfaces To VSX Bond Group?

Question asked by Daniel Taney on Apr 9, 2018
Latest reply on Jul 26, 2018 by jelle257658b7-4137-449e-8a0a-0baf97f9f08c

Good Afternoon,

 

I plan to add additional 10GB interfaces to an existing bond group in a VSX VSLS cluster. Is there any trick to doing this that may not be obvious? 

 

I planned on gracefully migrating all the VS's to a single cluster member using vsx_util vsls via the management server. Once failed over, I was going to issue a cpstop to the vacated Gateway to shut everything down.  

 

Then, in CLISH run:

add bonding group 0 interface eth1-03
add bonding group 0 interface eth1-04
add bonding group 0 interface eth2-03
add bonding group 0 interface eth2-04

 

After that, I was planning on rebooting the Gateway given its long uptime. Once it came back up, I was going to verify the cluster integrity with the new interfaces with cphaprob -a if.

 

Then, rinse and repeat with the other cluster member.

 

Is there anything else I need to do to make sure this goes as smoothly as possible?

 

Thanks!

 

Dan

Outcomes