AnsweredAssumed Answered

Displaying transceiver properties

Question asked by Maros Kukan on Nov 13, 2017
Latest reply on Jul 26, 2018 by Jozko Mrkvicka

Hello all,

 

Is there an east way how to display transceiver properties like the inserted type? So far I have tried through clish show interface ..,

 

[Expert@gw-4370e6:0]# ethtool eth3-01
Settings for eth3-01:
        Supported ports: [ FIBRE ]
        Supported link modes:   40000baseKR4/Full
                                40000baseCR4/Full
                                40000baseSR4/Full
                                40000baseLR4/Full
        Supports auto-negotiation: No
        Advertised link modes:  40000baseKR4/Full
                                40000baseCR4/Full
                                40000baseSR4/Full
                                40000baseLR4/Full
        Advertised auto-negotiation: No
        Speed: Unknown!
        Duplex: Unknown! (255)
        Port: FIBRE
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: off
        Link detected: no

 

Above, I am not sure whether the transceiver was even installed, in case of this 2-port 40G card, shouldn't it described it as external instead of internal? I have tried ethtool -m eth3-01, or ethtool -e but it seems these option are not supported in Gaia.

Outcomes