I would installe a cluster XL (with vSEC VE) but the synchronisation between the two gateways failed.
So I want use CLI to try to fix my problem but the default user name and password (admin and admin) doesn't work.
Any idea ?
Try this SK: https://supportcenter.checkpoint.com/supportcenter/portal?eventSubmit_doGoviewsolutiondetails=&solutionid=sk110354&partition=Internal&product=Security
Thanks for your response but I don't have access to this solution.
("To view this solution, higher access level is required.")
I guess that SK won't work since it's internal--apologies for not checking that before I posted it.
A cleaner approach, assuming you can still push policy to the gateway, would be the following: How to remotely reset Admin / Expert password on a Security Gateway from a Security Management Server
If you can't access this SK, please contact our TAC: Contact Support | Check Point Software
Note that during the first time wizard a new admin password has to be configured. If you are configuring a ClusterXL, then I assume the first time wizard was done. If this is the case, the default admin password may not be the good one :)
Thank you ! You are right. But I had already try and it didn't work.
However I find the problem. It seems that under vSphere's console the keyboard is inverted (azerty/qwerty).
So by paying attention of which password I choose in the first time wizard, it's all good !
Happy to hear that!
I remember that I had a similar issue in the past trying to authenticate with a user that I configured in a remote Domain Controller. It took me several hours until I realized that the keyboard of the remote server was different
Retrieving data ...