i am looking for command to stop one virtual firewall on vsx cluster ver. R77.30.
Some commands and tasks are recommended only to be run in consultation with TAC or under specific circumstances.
Could you please outline the scenario that you are faced with relating to the above requirement so that we might be able to assist further?
we have one VSX cluster with 10 virtual firewall , using VSLS . we want to stop 4 virtual firewalls on both side (active/standby). don't want to delete these permanently
That doesn't explain WHY you want to stop them, which is the question.
I believe we plan to support this functionality in the future, but do not currently.
I cannot answer for Amit's specific situation, but you can run into a situation where you need to change a file within the context of a single Virtual System followed by a cpstop/cpstart. In some environments it's easier to propose a change for CAB approval when you only are able to restart a single Virtual System and not the whole VSX gateway. This functionality would be very welcome in a future release.
As far as I know stopping one single VS is not supported
Retrieving data ...