AnsweredAssumed Answered

Cluster Sync lost after Get Interfaces with topology

Question asked by Maarten Sjouw on Jan 15, 2019
Latest reply on Jan 21, 2019 by Maarten Sjouw

Last week we ran into an issue that a cluster was loosing the sync status and the backup member went into down state.

Investigation learned that the Get Topology command erased the sync status of the Sync interfaces. There is no verification on the SmartConsole for this anymore, in R77.30 there was no way you could get out of the Topology window without a Sync interface set.

In R80.10 you can and you can push policy without any notification.

Outcomes