AnsweredAssumed Answered

Down tunnels are not displayed

Question asked by Martin Sykora on Dec 7, 2018
Latest reply on Dec 7, 2018 by Mike Andretta

In R80.10. In SmartView Monitor in the Tunnels on Gateway view I only see tunnels that are up and tunnels that I know that are down are not displayed. In the Query Properties I have the State filter set to Any. Yet no down tunnels are shown.
When I check in the down tunnel's respective Tunnels on Community view I only see "No data".
At first I thought that this is just the way it is - tunnels that are down are not presented - but than I found this screenshot in a Tunnels on Gateway on the Internet where there are all kinds of states in the the view.

I am thinking that something is not right on my side. Did anybody ran across such behavior?

Outcomes