Weird default route after upgrade

[Maarten_Sjouw]

I was preparing 2 12400's for installation, 1 was clean installed with R77.1 and 1 had a used R77.30 installation on it.

I copied the deployment agent 1573 onto it, updated CPUSE and copied the Check_Point_R80.10_T462_Fresh_Install_and_Upgrade_from_R7X.tgz file, which I then  imported.

Next step was installer clean-install <the imported package> and let it run and reboot.

All looked fine untill I was looking at the Mgmt interface, it had kept it's IP, and the default route and this is where it gets weird:

gw-7> show configuration static-route
set static-route default nexthop gateway address rt219bb100-100- on

I tried to add the correct route:

gw-7> set static-route default nexthop gateway address 100.100.219.9 on
RTGRTG0019 syntax error

With show route no routes are shown.

Adding any static route will just give me the same  syntax error??