Hi
we have a vsx clusterXL ,
atm the status is "active/down"
node 1 show MORE interfaces than normal using cphaprob -a if
we have 31 interface ,and this value is correct on noode 2 ,down ATM.
Node 1 report 47 Required interface. it's strange.
All the interfaces are up ,
We can reach every next-hop
NODE1 : active
[Expert@MI-DM-VSX1AOFE1:7]# cphaprob -i list
Built-in Devices:
Device Name: Interface Active Check
Current state: problem (non-blocking)
NODE 2 : DOWN
[Expert@MI-DM-VSX1AOFE2:7]# cphaprob -i list
There are no pnotes in problem state
* Issue 'cphaprob -l list' to show full list of pnotes
NODE 1 : Active
vsid 7:
------
Required interfaces: 9***
Required secured interfaces: 1
bond0 UP sync(secured), broadcast, bond Load Sharing
Virtual cluster interfaces: 6
eth1-02.156 100.97.12.225
eth1-02.1156 100.97.112.225
eth1-02.1106 100.97.110.81
eth1-01.206 100.97.20.81
eth1-03.306 100.97.30.81
eth1-02.106 100.97.10.81
NODE 2 : DOWN
vsid 7:
------
Required interfaces: 1
Required secured interfaces: 1
bond0 UP sync(secured), broadcast, bond Load Sharing
Virtual cluster interfaces: 6
eth1-02.156 100.97.12.225
eth1-02.1156 100.97.112.225
eth1-02.1106 100.97.110.81
eth1-01.206 100.97.20.81
eth1-03.306 100.97.30.81
eth1-02.106 100.97.10.81
[Expert@MI-DM-VSX1AOFE1:7]# cphaprob state
Cluster Mode: VSX High Availability (Active Up) with IGMP Membership
Number Unique Address Assigned Load State
1 (local) 10.255.255.77 100% Active Attention
2 10.255.255.78 0% Down
IT's strange because node 2 report the CORRECT number of interfaces ,but probably is down because node 1 "force" to see more interfaces.
Any suggestion ?
they are R77,30 with latest jumbo ;
don't suggest to udpate them : we tried to udpate to 80.40 ( with cpuse and update ,and with fresh install + vsx reconfigure but after the update all the vfw lost every ROUTE so we needed to rollback )
thx
NODE 2 : down
