Dear mates,
Currently, I have a VPN setup between 2 locations wherein Primary premises I have a cluster and at DR a single GW.
We are using a Site to Site VPN and now we need to add a 2nd L2 line connection as primary and keep the Site-to-Site as a secondary.
The GWs now, are connected with each end of L2 line and between there is also one switch. (GW -> switch -> end of L2 connection -> end of DR L2 connection ->GW)
Here are the steps we try so far:
1. Create a new VLAN for the L2 connection.
2. Assign the new VLAN’s IPs to the GWs and the switch interface.
3. Create new IP routes on both GWs to redirect traffic to pass from L2 Connection. -> Failed to work.
5. Create 2 new GWs as Interoperable Device and modify Site to Site VPN using new GWs object with internal L2 IPs. -> Failed to work.
6.Remove IP routes
The plan is to keep the Site to Site VPN and also pass the traffic through the L2 connection encrypted.
Regarding link redundancy mode, please note that we have also other remote locations and I think I can't use it.
Any ideas?
Thank you.
