Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Daniel_Kavan
Advisor

R80.40 - ipv6

Jump to solution

Hi, I have 2 interfaces dedicated to ipv6.  One external, and one DMZ.

My external interface is configured correctly in the web ui, and with a 'get topology' my dashboard is correct as well.

However, the clish command shows eth7's configuration on eth6 in the virtual cluster interfaces section.  And the eth7 configuration isn't even reported.

tcpdump shows nothing is getting to the VIPs.  As you might guess, outbound traffic is working internal and externally (the VIP isn't used).  But inbound ... nothing even shows up in tcpdump.

 

gate04> show cluster members interfaces secured

CCP mode: Manual (Unicast)

Interface Name: Status:

eth1 UP
eth5 UP
eth2 UP
eth6 UP
eth7 UP
eth8 UP
Sync UP
Mgmt Non-Monitored
eth1-01 UP
eth1-01 UP

 

 

0 Kudos
Reply
1 Solution

Accepted Solutions
PhoneBoy
Admin
Admin

Do your two interfaces with IPv6 on them also have IPv4 addresses on them?

View solution in original post

2 Replies
PhoneBoy
Admin
Admin

Do your two interfaces with IPv6 on them also have IPv4 addresses on them?

View solution in original post

Daniel_Kavan
Advisor

Yes, that was the issue.

With clusterXL you need to have ipv4 and ipv6 addresses defined for the cluster to see it.

0 Kudos
Reply