cancel
Showing results for 
Search instead for 
Did you mean: 
Create a Post

High avaibility 1200R checkpoint

Hello, i have some problems with my firewall 1200R checkpoint.

I have two firewall 1200R in HA with ClusterXL.

Visibly, it's work. And i have too configure two interfaces to get internet. The interfaces WAN and DMZ.

I configure them in mode high-avaiblitiy for internet connection and in HA with ClusterXL between the two firewall.

Moreover, i use OSPF on these two interfaces.

When i start my cluster with my configuration i get OSPF route on interface WAN. That's work on the two firewall of the cluster.

But if i disconnect the interface WAN of the two firewall, impossible to get OSPF route.

If i want to come back to the intitial state, that's to say to get OSPF route on the interface WAN, i need to reboot the cluster.

I have the same configuration on the interface WAN and DMZ.

What i'm doing wrong ?

1 Reply
Admin
Admin

Re: High avaibility 1200R checkpoint

Have you opened a case with the TAC by chance?

0 Kudos