- Products
- Learn
- Local User Groups
- Partners
-
More
Celebrate the New Year
With CheckMates!
Value of Security
Vendor Self-Awareness
Join Us for CPX 360
23-24 February 2021
Important certificate update to CloudGuard Controller, CME,
and Azure HA Security Gateways
How to Remediate Endpoint & VPN
Issues (in versions E81.10 or earlier)
Mobile Security
Buyer's Guide Out Now
Important! R80 and R80.10
End Of Support around the corner (May 2021)
Hello!
I have to replace about 30 SG80-Appliances (new appliances are 1450 appliances). Is there a way how I can transfer the configuration between a SG80 and a 1450 appliance. In the Clish "show config" is not available.
Best regards
Martin
Hi!
I have installed R75.20.69 (Bulid 983004056) and there is no "show configuration" in the clish available. The Check Point-Support told me, that there is now official way how I can transfer the configuration. I have to migrate the configuration manually.
Best regards
Martin
What version of code are you running on the SG80s?
I believe you should be able to do a show configuration if you're running an R75.20-based version.
This looks like your firmware is about R71.45 - there is no show config in that version, so you have to install a R75.20.x firmware for export! See also my CheckMates document Configuration transfer between different SMB models.
Hi!
I have installed R75.20.69 (Bulid 983004056) and there is no "show configuration" in the clish available. The Check Point-Support told me, that there is now official way how I can transfer the configuration. I have to migrate the configuration manually.
Best regards
Martin
I have to confirm that - i just had a look at my R75.20.69 SG80, and the command is missing there 😞
About CheckMates
Learn Check Point
Advanced Learning
WELCOME TO THE FUTURE OF CYBER SECURITY