cancel
Showing results for 
Search instead for 
Did you mean: 
Post a Question

Enable password field in endpoint vpn client

Hi,

I'm trying to build a new .msi as we are updating from E80.70 to E80.90.

I've rebuild the .msi but one problem still remains.

In E80.70, the user could write username and password in one place, and then pres connect.

In E80.90, they are required to enter username, press connect, and THEN type the password.

When they enter the username, there IS a password field, but it is disabled.

I've looked all over in trac.config/default to change this behavior, but wit no luck.

Does anyone have an advice on this?

Br,

Thomas

Tags (1)
3 Replies
Josh_B
Nickel

Re: Enable password field in endpoint vpn client

I've not seen that issue in E80.90. If I configure the authentication method for username and password, I don't have to enter the password in a separate box . 

Are you sure you have username and password in the authentication tab of the site you configured, under properties? 

0 Kudos

Re: Enable password field in endpoint vpn client

Hi Josh,

That is the problem. It says 'Standard' and I'm not able to chose the value you show.

However in the previous client, this was not a problem. And it's connecting to the same VS.

Br,

Thomas

0 Kudos
Admin
Admin

Re: Enable password field in endpoint vpn client

Recommend opening a TAC case.

How To Open a Case with TAC and/or Account Services

0 Kudos