cancel
Showing results for 
Search instead for 
Did you mean: 
Create a Post
Highlighted

show commands unable to run

Jump to solution

I am new to Check Point, Can some one help that i am unable to run show commands with Expert, clish mode. Let me know whats the issue.

 

1 Solution

Accepted Solutions
Vladimir
Pearl

Re: show commands unable to run

Jump to solution

So if your last prompt sign is a # , type "clish" and see if it will change to > .

Then run show commands.

Alternatively, if it is a # , you can type clish -c "show [parameters}" and execute it from there.

3 Replies

Re: show commands unable to run

Jump to solution
What is the last character of the prompt, is it a # or a > sign?
Which show command are you trying to run?
When you are in the hostname> prompt you are in clish, this is where you can use commands like:
show interface eth1
show route
show configuration interface
etc.
if you are at expert@hostname:0# prompt you are in expert mode and you cannot use show commands, only standard linux commands will work here, like:
ifconfig
ls -l
df-h
ps aux
tcpdump -i eth1 host 10.10.10.10
but also check point commands like
cphaprob stat
fw stat
cpstat os
etc.
Hope this helps a bit.
Regards, Maarten
Vladimir
Pearl

Re: show commands unable to run

Jump to solution

So if your last prompt sign is a # , type "clish" and see if it will change to > .

Then run show commands.

Alternatively, if it is a # , you can type clish -c "show [parameters}" and execute it from there.

Re: show commands unable to run

Jump to solution
Thanks