Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Champion
Champion

Which CLI command shows if active SmartCenter is HA?

Below commands are returning 1 on SmartCenter Servers (Non-HA) and primary active SmartCenter HA-Servers.

cpprod_util FwIsActiveManagement
cpprod_util FwIsHAManagement
cpprod_util FwIsFirewallMgmt
cpprod_util FwIsPrimary

However, cpview is able to differentiate between both.

sk148112 assumes the commands are executed on a SmartCenter HA server but doesn't provide a hint how to differentiate between a single active SmartCenter and a Primary Active SmartCenter HA.

Which command shows if I'm actually on an primary active SmartCenter-HA?

 

6 Replies
Highlighted
Champion
Champion

Working with this now:

if [[ -e $MDS_FWDIR/conf/peers.C ]]; then echo "SmartCenter HA"; fi
Highlighted
Participant

Would be interesting to know how cpview gets the info.

mgmt-ha.png

Highlighted
Employee++
Employee++

You can also run cpstat mg:

cpstat mg.jpg

0 Kudos
Reply
Highlighted
Participant

Thanks @Tal_Paz-Fridman,

unfortunately cpstat mg cannot differentiate if the management is HA or not.

On single managements cpview and cpstat show:

MGMT_cpview.pngMGMT_cpstat_mg.png

On Management-HA:

Prim_HA_cpview.pngPrim_HA_cpstat_mg.png

0 Kudos
Reply
Highlighted
Employee++
Employee++

But it will tell you if it is Active or Standby so perhaps that might help?

0 Kudos
Reply
Highlighted
Participant

Thanks @Tal_Paz-Fridman,

we want to know if the management is HA or not.

It doesn't matter at this stage if it's active or standby.