Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Participant

Multiple ISP Redundancy will it support in R80

Jump to solution

Do you we support ISP redundancy more than two ISP in R80

1 Solution

Accepted Solutions
Highlighted
Employee+
Employee+

R80.10 will not support more than 2 ISPs.

View solution in original post

0 Kudos
5 Replies
Highlighted
Employee+
Employee+

R80.10 will not support more than 2 ISPs.

View solution in original post

0 Kudos
Highlighted
Participant

In that case do we have any alternate  solution  where i can pitch the same

0 Kudos
Highlighted
Admin
Admin

If you can provide a little more details about your specific use case, we can figure out what might be the best approach. 

0 Kudos
Highlighted
Participant

   One of our customer using 4 Links ..

Hi,

1 link is dedicated Internet , remaining 3 are MPLS Point to Point Link which is connecting to their DC ..

 This 3 Links of MPLS wants load sharing requirement ..

 In that case how we can pitch the same.

0 Kudos
Highlighted
Admin
Admin

Check Point's ISP Redundancy assumes both connections will be solely used for Internet traffic.

What you describe sounds different, unless your goal is to use the Internet connections at these various datacenters reachable over MPLS as a backup. 

In general, you are probably going to need dynamic routing to achieve this. 

Equal cost multipath (ECMP) can be used to "load share" over the MPLS links, but you will have to have routers set up at the other end of the MPLS with the desired routing protocol (either BGP or OSPF depending on preference).

In terms of choosing whether to use the local Internet the MPLS link, I believe you can do this with route priorities (static routes usually have higher priority).

There are likely some limitations with this setup, namely connections will likely break when a failover occurs.

There may be others I'm not thinking of right now.

I recommend working with your Check Point SE offline to fully define the desired traffic flows, requirements, and limitations of your environment.

Based on that, we can come up with a workable solution.

0 Kudos