Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Participant

Hi Mates, Is there any way in Check Point to find any URL was Blocked or Allow?

Jump to solution

I mean, there is any form to search specific URL in Check Point and know is was blocked/allow or log?

Labels (1)
Tags (1)
0 Kudos
Reply
1 Solution

Accepted Solutions
Highlighted
Admin
Admin

The decision to allow or block something is based entirely on the policy you've configured.

This was discussed as part of this thread: Is there way to find out if site/ip is blocked by IPS/URLF via command line?

If you want to see if this was blocked in your system, you can look in your logs.

If you want to see how a URL is categorized by URL Filtering, see: URL Categorization | Check Point Software Technologies 

If you want to do a "what if" on your policy, see the following:Packet Mode, a new way of searching through your security policy in R80.10

View solution in original post

2 Replies
Highlighted
Champion
Champion

Sure, that's what SmartLog in R77.30 or Logs & Monitor in R80.10 was made for.

Logging and Monitoring R80.10 (Part of Check Point Infinity) 

0 Kudos
Reply
Highlighted
Admin
Admin

The decision to allow or block something is based entirely on the policy you've configured.

This was discussed as part of this thread: Is there way to find out if site/ip is blocked by IPS/URLF via command line?

If you want to see if this was blocked in your system, you can look in your logs.

If you want to see how a URL is categorized by URL Filtering, see: URL Categorization | Check Point Software Technologies 

If you want to do a "what if" on your policy, see the following:Packet Mode, a new way of searching through your security policy in R80.10

View solution in original post