Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 

How to create vlan on eth2-05 interface via clish on primary MHO

Hi experts,

I want to create the following configuration via clish, by connecting to one MHO only.
(Single-site DUAL-MHO setup, R80.20SP)

2020-05-23_21-00-30.png

I can create vlan 100 on eth1-05 and vlan 200 on eth1-06, but I can not configure the vlans for eth2-05 and eth2-06 interfaces.
It looks like the MHO has no "access" to the interfaces on the other MHO.
As you can see in the output below, I can configure the interfaces of the local-MHO, but not of the other MHO

MHO-1> add maestro port 1/5/1 vlan 100

MHO-1> add maestro port 2/5/1 vlan 100
NMSSG0001 Port 2/5/1 is invalid.
add maestro port 2/5/1
------------^^^^^^^^^^

MHO-1> add maestro port <TAB>

1/42/1 1/48/1 1/43/1 1/55/1 1/56/1 1/49/1 1/51/1 1/24/1 1/25/1
1/26/1 1/27/1 1/20/1 1/21/1 1/22/1 1/23/1 1/46/1 1/47/1 1/44/1
1/45/1 1/28/1 1/29/1 1/40/1 1/41/1 1/1/1 1/3/1 1/2/1 1/5/1
1/4/1 1/7/1 1/6/1 1/9/1 1/8/1 1/50/1 1/39/1 1/38/1 1/54/1
1/11/1 1/10/1 1/13/1 1/12/1 1/15/1 1/14/1 1/17/1 1/16/1 1/19/1
1/18/1 1/31/1 1/30/1 1/37/1 1/36/1 1/35/1 1/34/1 1/33/1 1/52/1
1/32/1 1/53/1

note:
I found out that I can connect to the other MHO and issue the "add maestro port 1/5/1 vlan 100" command to make it create the eth2-05.100 interface. I do not want to

...
TO READ THE FULL POST it's simple and free