- Products
- Learn
- Local User Groups
- Partners
-
More
Celebrate the New Year
With CheckMates!
Value of Security
Vendor Self-Awareness
Join Us for CPX 360
23-24 February 2021
Important certificate update to CloudGuard Controller, CME,
and Azure HA Security Gateways
How to Remediate Endpoint & VPN
Issues (in versions E81.10 or earlier)
Mobile Security
Buyer's Guide Out Now
Important! R80 and R80.10
End Of Support around the corner (May 2021)
I just recently install checkpoint r77.30 in standalone VM from the backup files. I can access my cli and it shows previous configuration yet i can't access webui and smart dashboard.
1. I reboot the machine and just for 5 -10 seconds i can access webui and after that it goes off. i can't ping
2. i tried with different vlan network and yet while i reboot i can access for 5-10 minutes then it goes
What could be the possible problem. Have you face that problem before or do you have any idea about it.
Help me Please, i need to extract that previous file
This should go in General Product Topics.
Was your management appropriately licensed when you did the backup?
Does your VM have the same IP address as the original?
If not, you probably don't have a license and, as a result, the product is blocking all traffic.
Apply an appropriate evaluation license.
Refer to: How to Request an Evaluation License
Thanks. Dameon.
Yes. IP address is the same.
I will try to apply for eval license and try it out again one more time.
Try running fw unloadlocal and see if that allows you to access the web interface again. Sounds like something was not set up properly and the derived IntitialPolicy is blocking you.
--
Second Edition of my "Max Power" Firewall Book
Now Available at http://www.maxpowerfirewalls.com
About CheckMates
Learn Check Point
Advanced Learning
WELCOME TO THE FUTURE OF CYBER SECURITY