Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
Matt_Sherman
Participant

R80.20.M1 log server unable to login after 1st time config

I have a new 5150 that came with R80.10 and I did a clean install to R80.20.M1.  The 1st time config wizard I selected log server.  I also said any ip and to use the gaia login and I put in my SIC key.  This completed.  After doing some other work my session timed out.  I did create a checkpoint host in SmartConsole.  When I tried to attach a license via smartupdate, it says product not found.  When I tried to log back in webui authentication fails.  I am also unable to log in via ssh.  I then tried to establish SIC and SIC is established.  However, the status is still unknown and I still cannot login webui or ssh.  We do have a tac case open, but are waiting for a call back so I figured I'd ask here to see if anyone else has seen these issues.

2 Replies
Maarten_Sjouw
Champion
Champion

When you are sure SIC is set you can use How to remotely reset Admin / Expert password on a Security Gateway from a Security Management Serve...  to reset the admin password from management. It will also work fine on a SE/Log server.

Regards, Maarten
0 Kudos
Dror_Aharony
Employee Alumnus
Employee Alumnus

Hi Matt,

I'm Dror Aharony from CheckPoint (drora@checkpoint.com) & I'd like to try to assist you, if possible.

Can you elaborate & share an updated status with more info here?

Also, can you send me an Email?

btw, I'm OOO tomorrow (Monday), so only limited availability.

Much appreciated.

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events