Create a Post
cancel
Showing results for 
Search instead for 
Did you mean: 
vivek_poudel
Explorer

NAT Template issue after enabling it on primary gateway.

I have an HA  in production environment on 5400 series and Smart405 as management.Primary gateway is not accessible after enabling NAT template and rebooting it.Neither it is accessible from sync interface,its ip or from Secondary gateway. Do i have to disable the NAT template using console or there is any way i can make it accessible?

1 Reply
Timothy_Hall
Champion
Champion

Unfortunately this behavior probably means that you made a typo in the fwkern.conf file.  Traffic destined to the gateway itself (like SSH management) is never accelerated by SecureXL, and therefore is not subject to NAT Templates.  Why did you enable NAT Templates in the first place?  As mentioned in my book there are fairly limited scenarios where NAT Templates will boost performance, and the fact that they can only be enabled/disabled via a fwkern.conf modification and reboot is a bit unnerving.

--
Second Edition of my "Max Power" Firewall Book
Now Available at http://www.maxpowerfirewalls.com

Gateway Performance Optimization R81.20 Course
now available at maxpowerfirewalls.com
0 Kudos

Leaderboard

Epsum factorial non deposit quid pro quo hic escorol.

Upcoming Events

    CheckMates Events