cancel
Showing results for 
Search instead for 
Did you mean: 
Post a Question

Log filter "Yesterday"

Hi,

I've noticed that the pre-defined log filter "Yesterday", in several environments (R80.10 with diferent jhf), doesn't work as expected. This means taht all the presented log entries under this filter are from today instead of yesterday. I've double checked clock and hardware clock and its not an issue - everything is in sync.

However this is not always true, meaning that some environments are working fine.

On the non-working environments there is no symptom of excessive logging or lack of hw resources.

Does anyone have been through this ?

Regards,

PB

1 Reply
Admin
Admin

Re: Log filter "Yesterday"

Is this on generated reports? Maybe this will be helpful: SmartEvent R80.x report generation failure 

If this is what shows up in SmartLog, you should probably open a TAC case so we can investigate: Contact Support | Check Point Software 

0 Kudos