cancel
Showing results for 
Search instead for 
Did you mean: 
Create a Post
Highlighted

Adding interfaces to gateway on management server

Hi

I have added an IP address to an additional interface on a live gateway cluster R80.10, via Gaia.

When adding additional interface for a new DMZ on the Management server R80.20, Gateway cluster properties what is the best way to "get interfaces" "with or without topology"?

Hopefully not causing an outage.

Thanks

0 Kudos
4 Replies
Admin
Admin

Re: Adding interfaces to gateway on management server

To not disrupt the existing settings on interfaces, just use Get Interfaces.

Re: Adding interfaces to gateway on management server

There are many people here that have had very bad experience with Get Interfaces with topology, messing up the way the intefaces were setup. So as Phoneboy says get them WithOUT topology. Another point here is that actually you don't need the topology when you have a single VLAN connected to it.
Even better from R80.20 (GW and Mgmt) on, you can use anti-spoofing based on routing for each interface.
Regards, Maarten

Re: Adding interfaces to gateway on management server

In the finish I did a manual add "Action, New Interface"
0 Kudos
Danny
Pearl

Re: Adding interfaces to gateway on management server

Perfect. That's what I always do as well > manually defining the topology and keeping it consistent to the GAiA configuration.

0 Kudos