cancel
Showing results for 
Search instead for 
Did you mean: 
Post a Question
Ankur_Datta
Nickel

sk105239 article not working when ISP redundancy configured in load sharing mode.

Hi All,

In my organization setup, I have 2 firewalls in cluster in active/standby mode and ISP redundancy configured in load sharing mode (50-50 ratio). The version firewall is running is R80.20. 

There is only one default route configured on firewall pointing to ISP-1. I can see failover mechanism is working fine when ISP-1 goes down. checkpoint firewall removes default route pointing towards ISP1 and place default route pointing to ISP2. 

But traffic is not traversing through ISP2 link. Traffic traverse through ISP-1 only even if i applied sk105239. 

Any suggestions please?

Thanks

2 Replies
Ankur_Datta
Nickel

Re: sk105239 article not working when ISP redundancy configured in load sharing mode.

Hi Gunther,

Just wanted to know for sk25152 : this is valid for active connections. I mean to say if i am accessing any server and primary link goes down will then traffic will nat to backup isp public link and traverse through backup link or i need to re-intiate the connection to server?

Thanks

0 Kudos